Shields Marine Type A1-15 (116-368) Low Permeation Series 368 Fuel Hose SOLD BY FOOT

SAE J1527 Type A1-15 – ISO 7840. Low permeation fuel hose has a plastic barrier veneer with NBR outer layer tube to limit permeation. Polyester reinforced and complies with EPA and CARB low permeation requirements. Weather/UV resistant NBR/PVC cover.Fuel feed – gasoline up to 85% ethanol blended fuels / diesel / bio-diesel all blendsMeets USCG Type A1-15 requirements for pleasure boatsISO 7840 Type A1.NMMA/CE type accepted. Temperature range: -20F to 212F

WARNING – Special care should be taken when coupling Shields series 331, 337 and 368 EPA approved barrier fuel hoses. Always use a lubricant when inserting a fitting. Oil based or other lubricants designed for rubber or plastic assembly should be used. Silicone is not recommended as it may cause coupling retention issues. Over-sized fittings should not be used. The fitting should slide into the hose with minimum, but some, resistance. Using fittings with oversized barbs may result in damage to the barrier layer. Sierra recommends the use of Oetiker stepless ear clamps or worm drive clamps to attach the fuel hose. Do not use wire ties or spring tension clamps. Over-tightening a worm drive clamp may result in damage to the inner layer and cause fuel to get in between the layers. This will cause the layers to separate and block the flow of fuel.

Fuel hose connectors, clamps and Fuel Tanks sold separately.